Series FH-220 Duplex Bag Filter Housing
VQ-FH220
Filter housing, flow 10 to 90 m³/h, rating 1 to 800 micron.
- FLOW
- 10 to 90 m³/h
- RATING
- 1 to 800 micron
- DESIGN PRESSURE
- 10 bar
- TEMPERATURE
- -10 to +120 °C
Why it is specified
A housing is half an answer. Every selection is quoted with the element, the seal material and the differential pressure at the design flow, so the running cost is on the quotation and not discovered later.
Typical applications
- Condensate protection
- Cooling tower side streams
- Paint and coating transfer
- Pre-filtration ahead of cartridge stages
Options and executions
- Davit arm for the lid
- Differential pressure gauge with a switch
- Jacketed shell for viscous media
- Material certificates to EN 10204 3.1
The full table.
Figures cover the whole series. The variant table below narrows them to a part number.
PERFORMANCE
- Design flow
- 10 to 90 m³/h
- Filtration rating
- 1 to 800 micron
- Clean pressure drop
- 0.08 to 0.26 bar
- Recommended change-out
- 0.8 bar differential
- Element count
- Two bags, switchable
MATERIALS
- Shell and lid
- 1.4404 stainless steel
- Internals
- 1.4404 stainless steel
- Lid seal
- EPDM O-ring
- Internal finish
- Ra 0.8 micron
CONNECTIONS AND RATINGS
- Inlet and outlet
- DN50 to DN100
- Vent and drain
- Fitted as standard
- Design pressure
- 10 bar
- Temperature range
- -10 to +120 °C
- Closure type
- Swing bolt, two lids
Stocked frame sizes.
| PART NUMBER | SIZE | CONNECTION | DESIGN FLOW | MATERIAL |
|---|---|---|---|---|
| VQ-FH220-10 | Size 1 duplex | DN50 | to 30 m³/h | 1.4404 |
| VQ-FH220-20 | Size 2 duplex | DN80 | to 65 m³/h | 1.4404 |
| VQ-FH220-30 | Size 2 duplex | DN100 | to 90 m³/h | 1.4404 |
FH-220, DS-FH-220
The datasheet is issued with the selection rather than downloaded blind, so the figures that arrive are the ones for your duty point. Ask for it with the quotation and it comes back as a PDF.
What is in it
- Selection data and the limits each figure applies at
- Dimensional drawings for every size in the variant table
- Materials of construction and the compatibility notes
- Installation, commissioning and maintenance intervals
- Spare parts list with the part numbers
Elsewhere in the catalogue.
FH-400
Stainless steel single-bag filter housing with a swing-bolt closure and an internal restrainer basket, for coarse and medium filtration on process and utility lines.
CF-250
Multi-round cartridge housing with a clamped closure, for fine and final filtration where the element is the specification and the housing is the frame around it.
FH-340
Filter housing, flow 20 to 240 m³/h, rating 0.5 to 100 micron.
FH-410
Filter housing, flow 30 to 400 m³/h, rating 25 to 500 micron.
Quote the FH-220 for your duty.
Send the process data and the line size. The quotation comes back with the selection, the calculation and the lead time on the stocked variants.
Vanteq Industrial is a fictional company created for demonstration purposes. This product does not exist. The specifications, performance figures, materials and datasheet references on this page are illustrative and must not be used to select, size or buy equipment.